Lighting The Side Burner - Brinkmann 810-6340-S Manual Del Propietário

6. If the burner does not light within the first few attempts, there is a problem with the gas supply. Turn
off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found
and corrected.
7. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off
the gas flow from the cylinder..
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual.

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and hold down side burner control knob and SLOWLY
(2 to 3 seconds ) turn to "HIGH". You should hear the
igniter click.
Note: Step 3 may need to be repeated 2-3 times to light
side burner.
4. If ignition does NOT occur in 5 seconds, turn control knob
to OFF, wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
5. To turn off, turn control knob clockwise until it locks in OFF position.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate
and repeat lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting"
section of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color
between 1"–2" when burner is on "HIGH".
See section in manual on burner adjustment to adjust flame.
10