Machine Configuration; Speed Adjustment - IRTEC smart Manual De Instrucciones

12. Machine configuration.

The machine configuration wizard starts after each start-up with the modification of the serial number, but it
can also be started in subsequent stages using the icon
on the settings page figure 74.
The procedure must be carried out by qualified personnel, as an incorrect configuration may lead to a
machine malfunction.
12.1.

Speed adjustment.

F1
F2
F3
F4
The two values that can be set on this page can be highlighted by means of the selection wheel. The value
selected can be modified by pressing it with the wheel. The increase/descrease scale can be modified
using the F5 key.
Once the values have been set by using the F8 key, you will go to the next page, the data will be stored
and loaded only upon completion of the configuration stage.
SMART
20/01/2020
91
Potential: speed adjustment control value, the maximum machine speed
can be used as a starting point. If the adjustment is very slow, the value
must be lowered, if on the other hand the system corrects too abruptly
without stabilising the speed (cogging), the value must be raised.
Number of revolution pulses: the number of pulses detected by the
inductive sensor inside the gearbox during a full revolution of the reel must
be entered in this field. This value is provided in the machine parameter
datasheet chapter 2, or it can be obtained experimentally.
F5
F6
F7
F8
49