Reel Dimensions; Hose Dimensions - IRTEC smart Manual De Instrucciones

12.2.

Reel dimensions.

F1
F2
F3
F4
Actual reel dimensions must be entered in this section. Specifically:

The width of the reel: in mm, it is the actual internal measurement.

Reel diameter: in mm, it is the diameter of the inner part in contact with the first hose loop.
This data is also present in the machine datasheet chapter 2 or can be measured.
12.3.

Hose dimensions.

F1
F2
F3
F4
This section concerns the characteristics of the polyethylene hose, the following data must be set correctly
(preferably checking it on the hose markings) in order for the system to function correctly:

Hose length: in m, it is the total length of the hose, and represents the maximum working length of
the trolley, normally the length on the hose is marked at each metre, therefore the value read at the
point closest to the trolley represents the hose length, or it can be obtained from the machine data
table in chapter 2.

Hose diameter: in mm, it is the external diameter of the hose (normally printed on the hose itself)
and present in the machine data table chapter 2.

Hose thickness: in mm, hose thickness value useful for calculating the head losses, it must be read
on the hose itself.
50
92
93
F5
F6
F7
F8
F5
F6
F7
F8
SMART
20/01/2020