System Diagnostics/Test - IRTEC smart Manual De Instrucciones

On this page it is possible to change the current date and time using the selection wheel/button and confirm
it using the F5 key. Check that the new date and time have been updated at the bottom right of the screen.
This page is part of the configuration sequence after the first start-up.
16.3.

System Diagnostics/Test.

This section is dedicated exclusively to maintenance technicians for quick system diagnostics since it will
be possible to check the status of all sensors and check the operation of the controllable components.
On this page it is possible to view the status of all inputs required by the system, if not physically present
the signal will be zero.
The first STATUS value represents a numeric value that identifies the function that the machine is
performing, this value is useful only for the service, below you can see:

the battery charge status.

The signal of the mechanical limit switch that indicates the complete return of the trolley.

The pressure value measured by the pressure transducer.

The physical status of the inductive sensor that counts the teeth of the chain.

The number of pulses detected by the system on the motion pinion (which based on the hose on the
reel represent the metres unwound)

The status of the inductive sensor installed on the litre counter to establish a quantity of water
consumed.
From this page it is also possible to access the page to control the data detected for chain slipping (only if
present) via the F3 key and the page to manually control the outputs via the F4 key only with machine
stopped.
74
F1
F2
F3
F4
160
F5
F6
F7
F8
SMART
20/01/2020