Work Cycle Start - IRTEC smart Manual De Instrucciones

the first value (next to the rubber) represents the partial hour counter which can be reset by pressing
and holding the F7 key for at least 5 seconds, the first password level is also required. The second
value represents the overall hours worked by the machine which are reset only if the serial number
is modified.
13.7.

Work cycle start.

Press the F1 button to start the START sequence which requires a series of pre-settings based on the
machine, in particular when the start button is pressed the following popup will appear.
Using the selection wheel/button only, the operator can first select the value to be modified and then set:

Initial pause time
is the time that the machine (in the start status then in irrigation mode) waits before adjusting the return
speed, see paragraph 6.3 for the indication on the main page.

Final pause time
is the time during which the machine continues the irrigation in the stop position (trolley limit switch
activated or end of last sector) before the END OF CYCLE.

Delayed start (only appears if the motorised inlet valve is present)
The delayed start can be enabled via the selection wheel/button, once activated it is possible to set the
start date/time also using the selection wheel/button.
SMART
20/01/2020
147
65