IRTEC smart Manual De Instrucciones página 60

In case of a machine in STOP mode, the start date/time coincides with the current one, while the arrival
one is that of the last calculation performed. If the machine is configured for delayed start (the operator can
set a desired start date/time) it may appear as follows
Where the hourglass focuses attention on the start date/time (if it has not yet occurred), while the arrival
date/time will be that estimated taking into account the delayed start and work settings.
If the pressure transducer is present, the box with the instantaneous pressure value will appear,
comparable to the mechanical pressure gauge.
If the pressure transducer is not present, the box will not be visible, but will appear in the Rainfall work
mode, in order to manually set the pressure read by the pressure gauge installed on the machine, this way
the theoretical calculations of the mm required will be more precise.
On the other hand, the instantaneous value of the machine speed calculated by measuring the number of
pulses on the motion transmission shaft expressed in m/H of the trolley/final boom is always present and
visible.
The graphical part of the main page instead contains the dynamic information on the trolley position (with
relative sector if configured) and the potential animation of the final raingun/boom and of the secondary
raingun positioned on the machine.
In the image above you can see that the trolley is located at 472m from the machine, which is irrigating
sector 2 and that the secondary raingun installed on the machine is also active.
Other information that may appear in this window is the elapsing initial and final work pause times if set.
The hourglass draws attention to the countdown of the initial time that begins at the START and keeps the
machine at zero speed by irrigating an area for the set time.
SMART
20/01/2020
60