Selecting The Operation Mode; Adjusting The Brightness - Stryker X8000 Light Source Manual Del Usuario

Selecting the Operation Mode

The X8000 has two operation modes, Run and Standby.
• RUN mode: The Run mode is used during normal operation. It
enables light output to be controlled by the brightness controls on the
front console panel.
• STANDBY mode: The Standby mode is used when the X8000 is
powered on, but not in use. It reduces the light output to a minimum,
thereby reducing the heat generated at the tip of the light cable or
scope when the X8000 is not being used.
To select either the Run or Standby mode, press the Mode Button. The LED for
the selected mode will illuminate.
W T
ARNING
OBJECTS AND POSSIBLE FIRE
S
THE LIGHT CABLE
CABLE ADAPTER
MINUTES TO COOL OFF AFTER BEING PLACED IN STANDBY MODE
AND THEREFORE MAY STILL RESULT IN FIRE AND
THE PATIENT
PROPERLY
THE PATIENT
EVEN WHEN THE DEVICE IS IN STANDBY MODE

Adjusting the Brightness

The X8000 has up and down buttons for adjusting the bulb brightness.
Press the up arrow to increase brightness, and press the down arrow to decrease
brightness. The selection will appear on the LCD as a percentage between 0 and
100.
When in Standby mode, the previous Run mode brightness level appears in the
upper right-hand corner. The Run mode brightness level can be reset while still in
Standby mode, by pressing the up and down buttons.
W T
ARNING
WILL BE GENERATED IN THE SCOPE AND THE TIP OF THE CABLE
A
THE MONITOR BEFORE ADJUSTING THE BRIGHTNESS LEVEL OF THE
LIGHT SOURCE
SOURCE TO THE MINIMUM BRIGHTNESS NECESSARY TO
ILLUMINATE THE SURGICAL SITE
O HELP PREVENT BURNS TO THE PATIENT
TANDBY MODE WHENEVER THE ENDOSCOPE IS REMOVED FROM
. T
,
AND LIGHT CABLE TIP WILL TAKE SEVERAL
,
USER OR INANIMATE OBJECTS IF NOT USED
. D
O NOT PLACE THE SCOPE OR THE LIGHT CABLE ON
,
ON THE DRAPES
HE HIGHER THE BRIGHTNESS
LWAYS ADJUST THE BRIGHTNESS LEVEL OF THE CAMERA AND
.
ADJUST THE BRIGHTNESS LEVEL OF THE LIGHT
,
ALWAYS PUT THE
,
HE SCOPE TIP SCOPE LIGHT POST
,
OR OTHER FLAMMABLE MATERIAL
,
THE MORE HEAT ENERGY THAT
.
FAILURE TO FOLLOW THIS
,
USER OR INANIMATE
X8000
IN
,
LIGHT
/
OR BURNS TO
.
,
.
11