Stel THOR 103 Manual De Instrucciones página 132

TECHNICAL
DESCRIPTION
a. Cutting speed too fast
b. Torch tilted too mach
c. Metal too trick
d. Worn torch parts
e. Cutting current too low
f. NON- genuine thermal dynamics Parts
2. Main arc Extinguishes
a. Cutting spees too slow
b. Torch standoff too high from workpiece
c. Cutting current too high
d. Work cable disconnected
e. Worn torch parts
f. NON- genuine thermal dynamics Parts
3. Formecessive dross Formation
a. Cutting spees too slow
b. Torch standoff too high from workpiece
c. Worn torch arts
d. Improper cuttng current
e. NON- genuine thermal dynamics Parts
4. Short Torch parts life
a. Oil or moisture in air source
b. Exceeding system capability (material too thick)
c. Excessive pilot arc time
D. AIR FLOW TOO LOW (INCORRECT PRESSURE)
e. improperly assembled torch
f. NON- genuine thermal dynamics Parts
12.4 ISPECTION AND REPLACEMNET CONSUMABLE TORCH PARTS
WARNING
Disconnect primary power to the system before disassembling the torch or torch leads
DO NOT touch any internal torch parts while the AC indicator light of the power supply
is ON.
REMOVE THE CONSUMABLE TORCH PARTS AS FOLLOWS
132
ENGLISH
THOR 103
COD. 6909500060
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
TECHNICAL
DESCRIPTION
a. Cutting speed too fast
b. Torch tilted too mach
c. Metal too trick
d. Worn torch parts
e. Cutting current too low
f. NON- genuine thermal dynamics Parts
2. Main arc Extinguishes
a. Cutting spees too slow
b. Torch standoff too high from workpiece
c. Cutting current too high
d. Work cable disconnected
e. Worn torch parts
f. NON- genuine thermal dynamics Parts
3. Formecessive dross Formation
a. Cutting spees too slow
b. Torch standoff too high from workpiece
c. Worn torch arts
d. Improper cuttng current
e. NON- genuine thermal dynamics Parts
4. Short Torch parts life
a. Oil or moisture in air source
b. Exceeding system capability (material too thick)
c. Excessive pilot arc time
D. AIR FLOW TOO LOW (INCORRECT PRESSURE)
e. improperly assembled torch
f. NON- genuine thermal dynamics Parts
12.4 ISPECTION AND REPLACEMNET CONSUMABLE TORCH PARTS
WARNING
Disconnect primary power to the system before disassembling the torch or torch leads
DO NOT touch any internal torch parts while the AC indicator light of the power supply
is ON.
REMOVE THE CONSUMABLE TORCH PARTS AS FOLLOWS
132
ENGLISH
THOR 103
COD. 6909500060
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it