Remote Control Buttons - LUCCI Air AIRFUSION MOTO Manual Del Usuario

AIRFUSION MOTO Installation Instructions
•
Press and hold the "
to the receiver of ceiling fan 2.
during the process, the indication light will flash slowly.
• Turn ON and change the speed of ceiling fan 2 by the remote to check the operation and successful
pairing.
• If pairing has been unsuccessful, repeat these set of steps again
RESET TO DEFAULT:
If you like to reset your remote to be compatible to all receiver, please press the "
during the process the indication light will flash rapidly.

REMOTE CONTROL BUTTONS:

Before you start using the remote, take the time to read through this section and get familiar with the button
and function of each button （Fig.12）
1 - LED Indicator
The red LED indicator on the top of receiver will flash when the
buttons are active.
2 - FAN OFF BUTTON:
Press the button to turn the fan off.
3 - FAN SPEED CONTROL BUTTON:
There are 6 available speeds. "1" button is for the lowest speed, and "6"
button is for the fastest speed.
NOTE: when you turn on the fan for the first time or switch the main
power to the controller, you need to start the fan on high "6" speed first
and then choose a lower speed. A 5-10 seconds is required to allow the
DC fan to respond to the remote each speed or fan direction selections.
4 - REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must
be operating to activate the reverse function.
5 - LIGHT CONTROL BUTTON: （the Moto Fan have not light）
Press the button to turn the light ON/OFF.
11 | P a g e
" button of remote 2 for 3-5 seconds within 30 seconds of switching the power ON
" button for 15 seconds,
Fig. 12