Publicidad
Idiomas disponibles
Idiomas disponibles
3.1AE ASSEMBLY STEp 8
3.1AE SHOWN
3.1
AE
CONSOLE
CONSOLE MAST
NOTE: Be careful not to pinch
any wires while attaching the
console or handlebars.
18
31AE_41AE_OM_Rev1_7.indd 18-19
All manuals and user guides at all-guides.com
HARdWARE fOR STEp 8 :
BOLT (DD)
CONSOLE CABLES
12 mm
Qty: 4
UPPER HANDLEBAR
* This step is for 3.1AE models only.
BOLTS (DD)
A
Open hardware for step 8.
PRE-INSTALLED
B
Attach the 3 console cables to the console.
SET SCREWS
Carefully tuck the Console cables into the
C
console mast before attaching the console.
HANDLEBAR BOOT
Attach console to console mast using 4
bolts (dd).
LOWER HANDLEBAR
D
Slide handlebar boots over upper handlebars.
E
Slide upper handlebars onto lower
handlebars making sure handlebars are joined
together completely. Secure upper handlebars
to lower handlebars using pre-attached
set screws.
Make sure upper handlebars are as far down as possible.
Handlebars can be damaged If not secured correctly.
F
Slide handlebar boots down to cover
handlebar attachments.
3.1AE ASSEMBLY COMPLETE!
4.1AE ASSEMBLY STEp 8
4.1AE SHOWN
HANDLEBAR
WIRE
AERO HAND GRIPS
BOLTS (DD)
UPPER HANDLEBAR
PRE-INSTALLED
SET SCREWS
HANDLEBAR WIRES
LOWER HANDLEBAR
NOTE: Be careful not to pinch
any wires while attaching the
aero hand grips or handlebars.
HARdWARE fOR STEp 8 :
BOLT (DD)
15 mm
Qty: 4
* This step is for 4.1AE models only.
A Open hardware for step 8.
B Carefully pull the handlebar wire from the aero hand
grip through the upper handlebar using the twist tie
located inside the upper handlebar and then discard the
twist tie.
C Pull the handlebar wire from the bottom of the upper
handlebar while sliding the aero hand grip onto the
upper handlebar to prevent the handlebar wire from
becoming pinched and create slack to connect the wire.
D Attach aero hand grip to upper handlebar using 2
bolts (dd).
E guide the handlebar wire through the top of the lower
handlebar and through the slot.
F Slide upper handlebar onto lower handlebar making
sure handlebars are joined together completely. Secure upper
handlebar to lower handlebar using pre-installed
set screws.
g Connect the handlebar wire from the upper
handlebar to the wire from the console mast.
H Repeat steps B – g on other side.
4.1
AE
19
7/13/11 11:08 AM
Publicidad
