AFG 3.1AE Manual Del Usuario página 7

ASSEMBLY STEp 2
4.1AE SHOWN
BOLTS (F)
SPRING WASHERS (E)
FLAT WASHERS (D)
INCLINE BRACKET
NUTS (J)
SPRING WASHERS (I)
FLAT WASHERS (H)
12
31AE_41AE_OM_Rev1_7.indd 12-13
All manuals and user guides at all-guides.com
HARdWARE fOR STEp 2 :
FLAT WASHER (D) SPRING WASHER (E)
16 mm 15 mm
Qty: 4 Qty: 4
FLAT
BOLT (G)
BOLT (F)
WASHER (H)
20 mm 35 mm
20 mm
Qty: 4 Qty: 4
Qty: 4
SPRING WASHER (I)
NUT (J)
18 mm
Qty: 4
Qty: 4
Open hardware for step 2.
A
Attach the guide rail set to the
B
main frame using 4 bolts (f), 4
spring washers (e) and 4 flat
washers (d).
MAIN FRAME
Attach the guide rail set to the
C
incline bracKet using 4 bolts
BOLTS (G)
(g), 4 flat washers (h), 4 spring
washers (i) and 4 nuts (j).
GUIDE RAIL SET
ASSEMBLY STEp 3
4.1AE SHOWN
BOLTS (L)
FLAT WASHERS (M)
CONSOLE MAST
CONSOLE CABLE
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
CRANK
PEDAL ARM
WAVY WASHER (N)
FLAT WASHER (K)
GUIDE RAIL
SPRING WASHER (B)
PEDAL ARM WHEEL
BOLT (O)
HARdWARE fOR STEp 3 :
BOLT (L) FLAT WASHER (M) WAVY WASHER (N)
15 mm 23 mm 22.5 mm
Qty: 4 Qty: 4 Qty: 2
BOLT (O) SPRING WASHER (B) FLAT WASHER (K)
20 mm 15 mm 20 mm
Qty: 2 Qty: 2 Qty: 2
Open hardware for step 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
Attach console mast to main frame
C
using 4 flat washers (m) and 4 bolts (l).
Slide wavy washer (n) over cranK
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the cranK using 1
E
flat washer (K), 1 spring washer (b)
and 1 bolt (o).
Repeat steps D–E on the opposite side of the
F
elliptical.
7/13/11 11:08 AM
13