Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEp 6
LOWER LINK ARM
TEFLON WASHERS (X)
16
31AE_41AE_OM_Rev1_7.indd 16-17
All manuals and user guides at all-guides.com
HARdWARE fOR STEp 6 :
4.1AE SHOWN
TEFLON
FLAT WASHER (Y)
WASHER (X)
17 mm
28.4 mm
Qty: 2
Qty: 4
A
Open hardware for step 6. Remove zip tie
securing axle in lower linK arm.
B
Align end of lower linK arm with bracket on
NUT (AA)
bottom of lower handlebar.
LOWER HANDLEBAR
C
Place teflon washers (X) on both sides of
FLAT WASHER (Y)
the lower linK arm. While holding teflon
washers (X) slide lower linK arm into bottom
SPRING WASHER (B)
end of lower handlebar.
BOLT (Z)
D
Secure the joint with 1 flat washer (y), 1
spring washer (b),1 bolt (z) and secure with
1 nut (aa).
E
Repeat steps B–D on the opposite side of the
elliptical.
ASSEMBLY STEp 7
SPRING WASHER (B)
WATER BOTTLE HOLDER
15 mm
Qty: 2
CONSOLE MAST
NUT (AA)
BOLT (Z)
Qty: 2
70 mm
Qty: 2
SCREWS (BB)
CONSOLE MAST BOOT
TOP CAP
SCREWS (CC)
REAR CAP
4.1AE SHOWN
TOP CAP REAR COVER
Open hardware for step 7.
A
Slide top cap and top cap rear cover
B
over console mast and snap into place.
Insert console mast boot over top cap
C
and snap into place.
Slide water bottle holder over
D
console mast and attach using 2
screws (bb).
Slide rear cap over rear stabilizer and
E
attach using 2 screws (cc).
NOTE: Be careful not to pinch any
wires while tightening screws.
REAR STABILIZER
HARdWARE fOR STEp 7 :
SCREW (BB)
SCREW (CC)
20 mm
15 mm
Qty: 2
Qty: 2
17
7/13/11 11:08 AM
Publicidad
