Washing Of The Coffee Groups; Tsc Washing (Mod.DE) - Rancilio classe 8 DE Uso Y Manutención

10.2.1 Washing of the coffee groups

At the fixed time, if the automatic washing (par.2.6)
mode is enabled, a message on the display requests
to wash the coffee groups.
Keep "ENTER" button pressed to start washing until
the display shows:
"Group Cleaning?"
"press <ENTER>"
If you press "enter" within 10 seconds, the following
cycle starts (if you do not leave this menu automa-
tically):
- The display shows:
"Insert blind
then <ENTER>"
- When you press "enter", the cleaning cycle starts
and the display shows:
"Cleaning runnign"
The machine carries out n. 10 cycles as follows:
- Starts dispensing from the groups for 10 sec.
- Pauses for 10 sec.
At the end of the 10 cycles, the display reads:
"Remove filterh.
press <ENTER>"
If you press "enter" the display shows:
"Rinsing"
The machine carries out n. 2 cycles as follows:
- Starts dispensing from the groups for 30 sec.
- Pauses for 30 sec.
Keeping ''esc'' pressed for 2 seconds, during the
cycle the current washing phase will stop and the
next phase will take place.
It is advisable to always complete the rinsing cycle
to remove any detergent residues.
N.B. In the washing and rinsing phases the groups
are operated alternatively.
In any case the washing of the coffee groups can
be enabled whenever necessary according to the
previously described procedure.
All manuals and user guides at all-guides.com
10.2.2 TSC Washing (mod.DE) (Fig.24)
At the set time, if the automatic washing mode is
enabled, a message on the display will request the
TSC washing.
Prepare a container with water and detergent to re-
move any milk. Insert the silicone pipe on the hose
holder, remove the nozzle and immerse it into the
container with detergent.
Immerse the lance into a half litre cold water bowl.
Keep "-" button (2 nd button) pressed to start washing
until the display shows:
"TSC Cleaning?"
"Press enter"
If "enter" is pressed within 10 sec.the following cycle
will be started (otherwise you will automatically exit
from this menu):
- the display will show:
" Prep.detergent"
"then <ENTER>"
- by pressing "enter" the cycle will be started and
the display will show:
"Washing under way"
no.2 dispensing cycles are carried out as follows:
- steam dispensing start for 20 sec.
- pause for 2 sec.
At the end of the 2 cycles the display will show:
"Prep.clean water"
" press <ENTER>"
Immerse the silicone pipe into a clean water bowl
for rinsing. Replace the water of the bowl where the
lance is immersed with cold clean water.
By pressing "enter" the display will show
"Rinsing under way"
and no.2 cycles will start as follows:
- steam dispensing start for 40 sec.
- pause for 2 sec.
Keeping ''esc'' pressed for 2 seconds, during the
washing cycle the current phase is stopped and the
next phase will take place.
It is advisable to always complete the rinsing cycle
to remove any detergent residues.
Rinsing phases cannot be avoided.
In any case the TSC washing can be enabled whene-
ver necessary according to the previously described
procedure.
If during the washing cycle the water where the lance
has been immersed exceeds 80°C, the message
below will be displayed
"water temperat.
too high"
and the current cycle will be interrupted.
In this case replace the water where the lance is
immersed with at least half litre of cold water and
press "enter" to continue the washing cycle.
65