MANUAL STARTER
CHECKING THE MANUAL STARTER
1. Check:
Start-in-gear protection lever
Cracks/wear/damage
2. Check:
Drive pawl
Cracks/wear/damage
Drive spring
Damage
3. Check:
Sheave drum
Cracks/wear/damage
4. Check:
Return springs
Damage
5. Check:
Starter wire
Frayed/wear/damage
NOTE:
When replacing the starter wire, cut it to
the specified length and then burn it end
so it will not unravel.
Apply water resistant grease onto the
new starter wire.
Starter wire length:
1,500 mm (59.1 in)
ASSEMBLING THE MANUAL STARTER
1. Install:
Starter spring 1
WARNING
When installing the starter spring onto the
starter case, use care so that the starter
spring does not pop out. To help the spring
stay compressed, wind it from the outside,
one turn each time.
5-6
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.