Finishing The Motor Installation - Kichler Parlour LED 300320 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

ELECTRICAL CONNECTIONS

Step 4. If your outlet box has a ground wire ( green or bare copper ) connect

Step 4.

If your outlet box has a ground wire ( green or bare copper ) connect

it to the fan ground wires : otherwise connect the fan ground wire to the

mounting bracket. Secure the wire connection with a plastic nut provided.

After connecting the wires, spread them apart so that the green and white

wires are on one side of the outlet box and black and blue wires are on the

other side. (Fig. 14)

NOTE: Carefully tuck the wire connections up into the outlet box.

NOTE:

Carefully tuck the wire connections up into the outlet box.

NOTE: Fan must be installed at a maximum distance of 30 feet from the

NOTE:

Fan must be installed at a maximum distance of 30 feet from the

transmitting unit for proper signal transmission between the transmitting

unit and the fan's receiving unit.

FINISHING THE MOTOR INSTALLATION

Step 1. Remove one of the two shoulder screws in the mounting bracket.

Step 1.

Remove one of the two shoulder screws in the mounting bracket.

Loosen the second shoulder screw without fully removing it. (Fig. 15)

Step 2. Assemble canopy by rotating key slot in canopy over shoulder

Step 2.

Assemble canopy by rotating key slot in canopy over shoulder

screw in mounting bracket. Reinstall the shoulder screw that was previously

removed, then retighten two shoulder screws securely. (Fig.16)

Mounting Bracket

Shoulder Screw

Fig. 15

Canopy

Shoulder Screw

Fig. 16

52" Parlour LED | 11

Tabla de Contenido

Tabla de contenido