Publicidad
Idiomas disponibles
Idiomas disponibles
I I t t e e m m
Electronic controls
Switches
Litter
Base
Wheels
Head section
E E v v e e r r y y 1 1 2 2 m m o o n n t t h h s s o o r r 2 2 4 4 h h o o u u r r s s
Inspect these items every 12 months or 24 hours, whichever comes first.
I I t t e e m m
Settings
Cylinder
Manual backup release handle
Litter
Base
Wheels
EN
52
I I n n s s p p e e c c t t
Hydraulic velocity fuse - place a weight of approximately 50
lb (23 kg) on the cot, raise the cot, lift the cot with two
operators, pull the manual backup release handle, rapidly
set the cot down, and make sure that the cot does not drop
Extend cot to raised position, measure and check load
height
Jog function operates
High speed retract works
No damage or wear to either switch
Both switches operate
No bent, broken, or damaged components
No damage or tears on cot grips
No bent, broken, or damaged components
Cot retaining post is secure. If not, replace the screw
No excessive damage to X-frame guards
Free of debris
No bent, broken, or damaged components
Grip bar has no excessive damage or tears
Load wheels are secure and roll
I I n n s s p p e e c c t t
Cot and fastener fit and function
Safety bar connects to the vehicle safety hook
Cylinder is adjusted - lock nut is tight and the cot stops
moving when it hits the dead stops
Returns to the stowed position
All welds are intact, not cracked, or broken
Warning labels present, legible
All welds are intact, not cracked, or broken
Check and adjust wheel locks
6516-209-005 Rev E.0
Publicidad
