35
Handhabung
Der Lithium-Ionen-Akku ist in geladenem Zustand
ca. eine Stunde einsatzbereit.
Der entladene Akku ist nach 5 Stunden (bei
ausgeschaltetem Gerät) vollständig aufgeladen.
Während der Ladezeit leuchtet die orangefarbene
LED i.
Wird das System 12 Wochen oder länger nicht
benutzt, sollten Sie die Ladung anhand der oben
aufgeführten Ladebalken überprüfen und ggf.
laden.
1
HINWEIS: Nach 20 Minuten ohne
Tastenbedienung schaltet der Monitor in
den Standby-Modus.
2
VORSICHT: Beschädigung des Netz-
kabels: Zum Entfernen des Netzkabels aus
der Steckdose nur am Steckergehäuse
ziehen, keinesfalls am Kabel.
5.10.17 Befestigung des Monitors an
einem Stativ
Stativhalterung auf der Rückseite des Monitors mit
4 Schrauben befestigen.
Die zum Lieferumfang gehörende VESA 75
Halterung (8401 YC) ist zur Befestigung an Rohren
mit 25 mm Durchmesser geeignet.
Halterung soweit zusammenpressen, dass die
Stativstange durch die Öffnungen geschoben
werden kann.
Handling
The lithium-ion battery can be used for approx.one
hour when fully loaded.
The discharged battery is fully charged after
5 hours (when the unit is switched off). Whilst
charging, the orange-colored LED i lights up.
If the system has not been in use for more than
12 weeks, please check that the system is
charged using the charge state bars listed above
and charge if necessary.
1
NOTE: After 20 minutes without key activity
the monitor switches to standby mode.
2
CAUTION: To prevent damage to the
mains cord, pull the plug from the outlet
and never the cable.
5.10.17 Attaching the monitor to
a stand
Attach the holder onto the back of the monitor
using 4 screws.
The VESA 75 holder 8401 YC belonging to the
scope of supply is suitable for securing on rods
with a diameter of 25 mm.
Press the holder together to allow the stand bar to
be pushed through the openings.
Manejo
La batería de iones de litio puede funcionar
durante aprox. 1 hora en estado cargado.
La batería descargada tarda unas 5 horas (con
el aparato desconectado) en cargarse de nuevo.
Durante el periodo de carga, el diodo luminoso i
aparece encendido de color naranja.
Si el sistema no se usa durante un período
de 12 semanas o más largo, se recomienda
comprobar el estado de carga comparándolo
con los segmentos representados arriba y, si es
necesario, cargar la batería.
1
NOTA: La pantalla entra en el modo
standby después de 20 minutos sin utilizar
el teclado.
2
CUIDADO: Deterioro del cable de red:
al retirar el cable del tomacorriente,
únicamente tirar del cuerpo del enchufe y
nunca del cable mismo.
5.10.17 Fijación del monitor a
un trípode
Fije el soporte para trípode mediante 4 tornillos a
la cara posterior del monitor.
El soporte incluido en el suministro VESA 75 (8401
YC) está diseñado para su fijación a tubos con un
diámetro de 25 mm.
Apriete el soporte hasta que la barra de soporte
extensible pueda empujarse a través de los
orificios.