Publicidad
Idiomas disponibles
Idiomas disponibles
4. Install the Valve
Offset Foot
Board Mount
CAUTION: Risk of product damage. Do not apply excessive heat near the valve. This valve contains plastic and
rubber components that will melt if heat is directly applied.
IMPORTANT! If your water supply has high amounts of particulates, install wye strainers in the supply lines.
Route 1/2" (3/4" PEX) dedicated water supply lines. Use unions to install removable pipe segments to the valve inlets to
allow access for periodic cleaning of the inlet filters.
Install shut-off valves and water-hammer arrestors in the supply lines before the valve.
Hold the valve up to the installation location. Verify fit and mark the hole locations.
Predrill the holes.
Secure the valve with the washers and screws. Do not overtighten!
IMPORTANT! When routing piping, the number marked at each valve outlet must correspond to the appropriate shower
fitting for preprogrammed or custom showering experiences to function properly. Refer to the Homeowners Guide for
more information.
Route the piping from the valve outlets to the appropriate shower fitting following the recommended pipe fitting sizes
listed.
Connect the hot and cold supply lines to the appropriate valve inlets. Hot is red and marked with "HOT," cold is blue
and marked with "COLD."
Secure all piping to the framing.
1145587-2-E
Cross Brace Mount
Water-Hammer Arrestor
10
1/2" Union
Shut-Off Valve
Kohler Co.
Publicidad
