Kohler K-528-K1 Instrucciones De Instalación página 13

7. Clean the Inlet Filters
Copper Tube
Nut
CAUTION: Risk of personal injury. The valve may contain hot water. Be careful when draining any residual water.
Turn OFF the water supply to both inlets.
Disconnect the power.
Unthread the plastic nuts from the hot and cold inlets.
Remove the copper tubes. The O-ring and filter may be attached to the end of the tube.
If the filter remains in the check valve, use a small flat-blade screwdriver to gently pull the check valve from the valve
inlet.
Remove the filters from the copper tubes or check valves.
Clean the filters to remove any dirt or debris.
Rinse or replace the check valves and filters.
Reassemble the inlet connections.
Kohler Co.
Check Valve
Filter
O-Ring
Seal
13
Boot
Split
Boot
1145587-2-E