Erreka VIVO-D103 Manual Del Instalador página 51

Connection of photocells
Connection of the garage light
Connection of the battery

Shown below is an example of the connections of a
KLPMUTO photocell as a safety device.
1 Connect the NC contacts of the photocell (1) or of
any other safety device (safety strips) to the
corresponding connector of the control panel.

Correctly programme the microswitches DIP1 and
DIP2 (see the photocell instructions).

The 24Vac connector can be used to feed the
photocell.
O
If a safety device is not installed, make an electrical
bridge.

When starting the opening operation, the panel
closes the relay contacts (LG), as a voltage-free
button, for 3 secs.
1 Connect the NA contacts, free of voltage, to the
garage light timer, automatic stair light, teleswitch
or other appropriate device (DLG).

Do not connect the lights directly to these
connectors.

Do not connect the mains phases to these
connectors, as this will cause a short circuit.

The panel has battery connection terminals for
emergency operation in the event of interruption to
the electricity supply.

The battery connection is optional, and is not
necessary for the correct operation of the panel.
1 Connect the battery terminals to the corresponding
contacts on the panel.
O
Respect the polarity.

The control panel automatically recharges the
battery when the electricity supply is restored.

When running off the battery, the gate moves more
slowly throughout the travel.
P181J
INSTALLATION
VIVO-D103 / ADB30 Control Panel
47