Maintenance And Diagnosis Of Failures; Maintenance; Failure Diagnosis - Erreka VIVO-D103 Manual Del Instalador

MAINTENANCE AND DIAGNOSIS OF FAILURES

1

MAINTENANCE


Before carrying out any maintenance operation, disconnect the device from the power supply.
1 Frequently check the installation in order to discover
any imbalance or sign of deterioration or wear. Do not
use the device if any repair or adjustment is necessary.
2

FAILURE DIAGNOSIS

Diagnosis LEDs and cutouts
SW1 General power switch
F1
Electronic cutout (0.8A)
F2
Power circuit cutout (10A)
F3
Motor cutout (10A)
DL1
Opening and closing signal (NA)
DL2
Photocell signal (NC)
DL3
Opening limit switch signal (NC)
DL4
Closing limit switch signal (NC)
DL6
Operation interrupted (due to detection
of obstacle or alternative stop)
52
Installation Manual
2 Check that the operation and safety devices
(photocells or safety strips), as well as their
installation, have not suffered any damage from the
weather or external agents.
DL7
Gate open (totally or partially)
DL8
Microcontroller power supply
DL9
Electronic circuit power supply
DL10 Power supply 230 Vac
DL11 Opening relay activated
DL12 Closing relay activated
DL13 Slow speed relay activated
DL14 Garage light relay activated
DL15 Dead Man closing button signal
DL16 "Flashing light" indicator