Programming Of The Opening And Closing Travel - Erreka VIVO-D103 Manual Del Instalador

3

PROGRAMMING OF THE OPENING AND CLOSING TRAVEL


The programming of the pedestrian opening travel of the gate can be done using the ST2 mini-button, the wall
key or the remote control.

Before programming, ensure there is no person, animal or object in the radius of action of the gate
and the mechanism.
Start programming mode
Programme the opening
Programme the closing
Finish the programming mode
1 Place DIP3 in "OFF".

The travels of the gate both in opening and
closing will be memorised.
PROGRAMMING AND STARTING UP
O
Ensure that the limit switches are correctly set (see
the operator instructions manual).
1 Place DIP1, DIP2 and DIP3 in OFF (Dead Man mode).
2 Close the gate by pressing ST2.
3 Place DIP3 in "ON" (operation recording), DIP1 and
DIP 2 in "OFF".
1 Start the opening: press ST1; the gate begins to
open at slow speed.
2 Start the quick speed in opening: press ST1 at the
point chosen for the start of fast speed (AR).
3 Start soft stop in opening: press ST1 at the point
chosen for the start of soft stop (AL).
4 Finish the opening: the gate halts automatically
when reaching the opening limit switch (FCA).
1 Start the closing: press ST1; the gate begins to close
at slow speed.
2 Start the quick speed in closing: press ST1 at the
point chosen for the start of fast speed (CR).
3 Start soft stop in closing: press ST1 at the point
chosen for the start of soft stop (CL).
4 Finish the closing: the gate halts automatically
when reaching the closing limit switch (FCC).

The positions in which the leaf begins to speed
up and slow down, both in opening and in
closing, will also be memorised.
VIVO-D103 / ADB30 Control Panel
49