Install The Shading; Attach The Magnetic Hold-Down Brackets (Optional); Operation; Operate The Shading - Levolor Sheer Shadings Manual De Instalación

INSTALLATION

Install the Shading

•
Position the shading so that
the front faces you.
•
Slide the headrail into the
installation brackets so the
edge of the headrail is between
the lever and the bracket, as shown.
•
Firmly push the headrail into each bracket until it clicks and the
lever snaps to the right side of the bracket.
IMPORTANT: Carefully pull on the headrail at each bracket to ensure
it is installed securely.

Attach the Magnetic Hold-Down Brackets (Optional)

•
Lower the shading keeping the vanes closed.
•
Place the magnetic hold-down bracket onto the bottom rail
just inside the end cap, oriented as shown.
•
Hold the bracket while opening and closing the vanes
(it may be necessary to have someone else assist you).
Adjust the bracket to the best overall position.
•
Mark the screw location using the mounting options shown below.
— The screw should be placed in the middle of the channel.
This will allow for adjustment.
Outside Mount
Preferred
Inside Mount
Preferred
10
Cordless Operating System
20-0037-012_Sheer_Shadings_Cordless_F_010621.indd 10-11
Lever
Headrail
Installation
Bracket
Slide the Headrail
between the Lever
and the Bracket.
Bottom
Rail
Hold-Down
Bracket
Alternate
Alternate
•
Drill the screw holes using a / " drill bit.
3
32
CAUTION: Use drywall anchors when mounting into drywall.
•
Attach the hold-down brackets to the mounting surface
using the screws provided.
•
If necessary, adjust bracket height by loosening the screw
and sliding the bracket up or down.

Operate the Shading

To Lower the Shading
•
Gently pull down on the hinge pull tab.
To Open the Vanes
•
Lower the shading all the way down and continue pulling down on the handle until
the vanes open.
To Close the Vanes and Raise the Shading
•
Pull down on the hinge pull tab slightly (1"-2") and release. The vanes will close first
and then the shading will retract into the headrail.
NOTE: With inside mounted shadings, you may need to pull the hinge pull tab away
from the window to release the locking mechanism and retract the shade.
NOTE: To hide the pull tab, rotate the tab backwards under the bottom rail once
the shade is set in the desired position.

OPERATION

Adjust the
bracket
using the
channel.
11
Cordless Operating System
1/6/21 4:48 PM