Installation Overview; Inside Mount - Levolor Sheer Shadings Manual De Instalación

INSTALLATION

Installation Overview

•
Your order will include the correct number of installation brackets for your shading
width, as shown in the table below.
•
Shading orders may also include spacer blocks or extension brackets, if they were
specified for added clearance.
— Extension brackets are used for side mount shadings, as well.
Installation Bracket
Panel Width
18" – 36"
36 / " – 79"
1
8
79 / " – 84"
1
8
•
Two-On-One Headrail Shadings. Two additional installation brackets are provided.
Mounting Types and Window Terminology
If the installation brackets are mounted correctly, the rest of the installation process
follows easily. To prepare for this important first step, review the mounting types and
basic window terminology illustrated below.
Molding
Head Jamb
Jamb Jamb
Collectively, the sill and
jambs are called the
"window casement."
Sill
Shim– A thin strip of material used to align parts to make them fit.
•
Refer to the appropriate page below based on your order:

— Inside Mount

Page 7
— Outside Mount Page 8
— Side Mount Page 10
6
Continuous Cord Loop Operating System
20-0034-033_Sheer_Shadings_Cont_Cordloop_F_010621.indd 6-7
For Added Clearance
Brackets
2
3
4
/ " and / "
1 1
4 2
Spacer Blocks Extension Bracket
Outside Mount
Inside Mount
Shading mounts
Shading fits within outside window
window opening. opening.
CAUTION: Failure to follow ALL installation instructions may cause the
!
shading to fall, possibly resulting in injury or property damage.
INSIDE MOUNT
Mount the Installation Brackets
•
Mark 2" to 3" from each jamb for bracket location.
— If more than two installation brackets came with your order, space additional
bracket(s) evenly between the two end brackets and mark their location. Mount
into wood whenever possible.
Single Headrail Shadings.
2" to 3" Space Evenly
Limit stops should be equal
Jamb
distance from the ends of headrail.
Two-On-One Headrail Shadings.
NOTE: Two additional installation brackets should be placed on each side of the panel split.
Space Evenly
Space Evenly
2" to 3"
3"
Panel Split
Jamb
•
Center the brackets on your marks, then mark the screw hole locations.
— The minimum casement depth for installation brackets is 1".
Mark location for the screws within the slots in the bracket.
The bracket location can be adjusted back or forth based
on the casement depth.
— The minimum casement depth for a fully recessed mount is
3 / ". Mark location for the screws within the slots in the
1
4
bracket. The bracket location can be adjusted back or forth
based on the casement depth.
IMPORTANT: The front edges of the brackets must be level and aligned to each other.
CAUTION: Failure to properly align the brackets could result in the headrail
!
releasing from the brackets, causing the shading to fall, possibly resulting in
injury or property damage.
INSTALLATION
WINDOW SIDE
Space Evenly 2" to 3"
Jamb
ROOM SIDE
WINDOW SIDE
Space Evenly 2" to 3"
3"
Limit Stops
Jamb
ROOM SIDE
Casement
Depth
7
Continuous Cord Loop Operating System
1/6/21 4:47 PM