Travel Limits - Levolor Sheer Shadings Manual De Instalación

Programming

Travel Limits

This procedure will adjust the travel limits on all blinds and
shades assigned to a channel.
Upper and lower travel limits are set at the factory during
production to your order specification. Upon installation,
adjustment of these limits may be necessary to better suit
your needs.
Take care adjusting limits to avoid damage to product.
Lower limits cannot be adjusted on sheer shades.
NOTE: If you exit programming before you finish adjusting the
travel limits, the motor will take the previous limits..
Adjust the Upper Limit
Use the
1
channel.
Press and hold the   up and   stop buttons
2
simultaneously for about 5 seconds until the motor
jogs x 1 and/or beeps x 1.
Use the   up and   down buttons to raise the blind
3
or shade to the desired highest position.
Press and hold the   up and   stop buttons
4
simultaneously for about 5 seconds until the motor
jogs x 2 and/or beeps x 3.
Adjust the Lower Limit
Use the
1
channel.
Press and hold the   down and   stop buttons
2
simultaneously for about 5 seconds until the motor
jogs x 1 and/or beeps x 1.
Use the   up and   down buttons to lower the blind
3
or shade to the desired lowest position.
Press and hold the   down and   stop buttons
4
simultaneously for about 5 seconds until the motor
jogs x 2 and/or beeps x 3.
Remote Control Guide
-
and + buttons to select the appropriate
-
and + buttons to select the appropriate
12
Home