Favorite Position - Levolor Sheer Shadings Manual De Instalación

Programming
Pair Remote to Blind or Shade
Use the
1
Press and hold the programming button on the
2
motor (about 2 seconds) until the motor jogs x 1
and/or beeps x 1.
In the next 10 seconds, press and hold the   stop
3
button on the remote until the motor jogs x 2 and/or
beeps x 3.
NOTE: Repeat steps 1-3 to unpair remote.

Favorite Position

To send to favorite position, press and hold the   stop button.
Favorite position is preset, but can be reset to fit your
needs. To create a new favorite position, you must first
delete the existing favorite position.
This procedure will set the favorite position on all blinds
and shades assigned to a channel.
Delete Favorite Position
Use the
1
delete the favorite from.
Press one P2 button in the battery compartment of
2
the remote until motor jogs x 1 and/or beeps x 2.
Press and hold the   stop button on the remote
3
until the motor jogs x 1 and/or beeps x 1.
Press and hold the   stop button on the remote
4
again, until the motor jogs x 1 and/or long beeps x 1.
Set Favorite Position
Use the   up and   down buttons to move blind or
1
shade to the desired position.
Press one P2 button in the battery compartment of
2
the remote until motor jogs x 1 and/or beeps x 2.
Press and hold the   stop button on the remote
3
until the motor jogs x 1 and/or beeps x 1.
Press and hold the   stop button on the remote
4
again, until the motor jogs x 2 and/or beeps x 3.
Remote Control Guide
-
and + buttons to select the channel to pair.
-
and + buttons to select the channel to
9
Home