Krampouz CSRS4 Manual De Instrucciones página 26

Practical Tips
• If the batter slips on the plate or sticks to the spreader: do not grease, there is too much fat on
the plate. Bad batter can cause the same effect. Remove the excess oil.
• If the batter just bubbles: either it is too runny, or it has gone bad, or else the plate is too hot.
• If the plate just sticks: lightly grease with a little edible oil.
• If the batter bubbles and sticks to the plate, either:
the plate has not been adequately seasoned: proceed to finish the seasoning.
the seasoning is burnt on: you need to strip the plate back and season it again.
the seasoning is burnt onto, or lifting off the plate: rub the plate with the APA1 Krampouz
abrasive stone, and season it again.
• If filling crêpes on the plate used for spreading:
Avoid toppings that can damage the seasoning (e.g. lemon, tomato).
Wipe the plate before spreading the next crêpe.
• Do not polish the plates, because the seasoning will not adhere as well.
Recipes
Buckwheat Pancakes
To make 15 crêpes - Add 250 g of buckwheat flour to a bowl with 1 tablespoon of wheat flour, 1
teaspoon coarse salt, 1 egg and 12 cl of water. Beat into a compact ball. Add 12 cl of semi-skimmed
milk, stir then beat for about 5 mins until you obtain a perfectly smooth batter. Gradually add 36 cl
of milk.
Wheat flour Pancakes
To make 20 crêpes - Add 1 tablespoon of buckwheat flour to a bowl together with 100-125 g of sugar
(to taste), 1 level teaspoon of coarse salt, 2 eggs, 25 g of melted butter or 1 tablespoon of oil, 1 sachet
of vanilla sugar or other flavours, and 10 cl of water. Beat all the ingredients together, gradually
adding 250 g of wheat flour and 12 cl of semi-skimmed milk until you have a smooth batter with no
lumps remaining. Then stir in 38 cl of milk.
Adjustments
Adjustments to this gas appliance must be carried out by qualified installers or technicians.
If changing the type of gas supply, it is essential to replace the injectors, adjust the air intake and the
idle flame (see the table on pages 21-23 and the appliance drawings on pages 3-5.
Changing the injectors
On an installed appliance, before changing the injectors and making the new adjustments, close the
valve on the supply pipe or gas cylinder.
Refer to the diagrams and do the following:
1. Close the valve on the supply pipe or gas cylinder.
2. Turn the appliance upside down.
3. Unscrew the feet and remove the bottom plate (see Fig. 2).
- 26 -