Assembly - eder ESG-C 400200 Instrucciones De Operación

13 Attachments with chain drive
Danger from leaking fuel!
If the fuel tank inlet is not properly closed, fuel may leak and
pollute the environment.
> Before transportation, check whether the fuel tank inlet is
correctly closed.
> When transporting the device on vehicles, secure it against
tipping over.

Assembly

Danger during assembly with the drive motor running!
This may result in injury.
> Switch off the drive motor before assembling the unit and
secure the device against being switched on again.
Danger from changes to the device!
This may result in injury.
> Only carry out assembly work described in this manual.
> Do not adjust the support, the chain, the knives or the milling
head while the engine is running. The chain must be correctly
tensioned.
> Only use original spare parts. These can be ordered directly
from Eder Maschinenbau GmbH or from your dealer (see
back page for address)
Converting and using the chainsaw with the Eder
attachments voids the chainsaw's warranty. Eder
Maschinenbau GmbH accepts no liability for damage to the
chainsaw!
ATTENTION
WARNING
409001_01 | 12.2020