Eder Groove Cutter Enf-C; Eder Wire Brush Erb-C - eder ESG-C 400200 Instrucciones De Operación

23 Attachments with chain drive
> Push the knife onto the knife gauge until the desired setting
height (0.2 mm, 0.4 mm, 0.6 mm) is reached.
> Retighten the knife screw. Tightening torque: 35 Nm

EDER Groove Cutter ENF-C

Sharp knives are required for optimal work with the EDER groove
cutter ENF-C.
Up to three knives can be fitted to vary the cutting width.
> Loosen the nut and put the desired number of knives on the
shaft.
> The knives can be resharpened several times.
> Put the washer and the nut on the shaft
> Tighten the nut again to 35 Nm.
Fig. 10: Replacing knives on the groove cutter
> Replace the clamping nut after each disassembly!

EDER Wire Brush ERB-C

Changing the wire brush
Fig. 11: Changing the wire brush
ATTENTION
409001_01 | 12.2020