Eder Bark Beetle Cutter Ebf-C - eder ESG-C 400200 Instrucciones De Operación

409001_01 | 12.2020
> Unscrew the drive sprocket using the pin wrench.
> Unscrew the short bearing shaft and the long bearing shaft.
> Remove the wire brush from the housing and loosen the locking
plate by bending back its bent lug so that the grooved locknut can
turn freely.
> Using the wrench, unscrew the grooved locknuts. The wire brush
can then be pushed off the shaft.
> When reassembling, make sure that the locknuts are firmly
seated (35Nm) and bend one lug of the locking plate back into
the groove of the locknut.
> Remount the short and long bearing shafts and tighten them.
Tightening torque: 35 Nm
> Screw the drive sprocket back on and tighten it using the pin
wrench.

EDER Bark Beetle Cutter EBF-C

Sharp knives are required for optimal work with the EDER Bark
Beetle Cutter EBF-C.
Blunt knives can be sharpened manually using normal
i
grinding wheels.
Replacing knives
> Unscrew the drive sprocket using the pin wrench.
> Unscrew the short bearing shaft and the long bearing shaft.
> Remove the shaft from the housing and loosen the locking plate
by bending back its bent lug so that the grooved locknut can turn
freely.
> Using the wrench, loosen the grooved locknut. The knives can
then be pushed off the shaft.
> When reassembling, make sure that the locknuts are firmly
seated (35Nm) and bend one lug of the locking plate back into
the groove of the locknut.
> Remount the short and long bearing shafts and tighten them.
Tightening torque: 35 Nm
> Screw the drive sprocket back on
Attachments with chain drive
EN
24