Commissioning And Operation; Starting The Engine - eder ESG-C 400200 Instrucciones De Operación

17 Attachments with chain drive

Commissioning and operation

Damage to knives and tools!
Nails, adhering sand and other foreign bodies can damage the
knives and tools of the attachment.
> Check the logs to be worked before each use. If necessary,
remove nails, sand and other foreign objects before milling.
Before starting the motorised handheld device, make sure you have
safe working conditions. Check that
> the attachment has been correctly mounted,
> the chain is sufficiently tensioned and not damaged,
> the chain brake is functional,
> all knives and tools are correctly mounted and firmly seated
(tightening torque 35 Nm)
> the handles are clean and dry,
> both the fuel tank and the device are located outside of
flammable environments. Note that closed, empty fuel tanks may
contain explosive vapours.

Starting the engine

Danger of injury due to rotating tools!
After you have released the throttle trigger, the device will
continue to rotate for a short time (freewheel).
> Before starting the engine, make sure that all protective
housings and protective plates are fitted to the attachment.
> Place the motorised handheld device on the ground so that the
device does not touch any foreign objects.
> Never start the device in a hanging position.
> Keep the device away from your body during work.
> Make sure that no one is in the working area of the device.
ATTENTION
CAUTION
409001_01 | 12.2020