Operation - eder ESG-C 400200 Instrucciones De Operación

409001_01 | 12.2020

Operation

WARNING
Risk of injury due to unsafe standing position!
There is a risk of injury if your standing position is not stable or if
you work overhead.
> Always take a safe and stable position.
> Never work on icy or wet surfaces, as there is a risk of
slipping.
> Never work on ladders or in unstable positions.
> While working, hold the device firmly with both hands so that
no parts of the body can approach the chain, the tool head or
the exhaust pipe. Grasp firmly the throttle handle with your
right hand and the front handle with your left hand. This also
applies to left-handed persons.
> Do not hold the device above your head when working and
always use both hands when working.
> Work calmly and carefully with good visibility and adequate
lighting.
Risk of injury!
If you do not observe the following points, injuries are possible
due to rebounding of the device.
> Only work on wood with the device (except for the Wire Brush
ERB-C).
> During work, make sure that the cutter head does not touch
any foreign objects (stones, glass, metal objects, etc.) that
could damage the cutter head or the chain
> When the engine is running, place the cutter head or wire
brush on the trunk surface only at operating speed.
> Make sure that the throttle trigger is not blocked by the
throttle lock when working with the device, as in this case it is
not possible to control the rotation.
> Check that the knives are firmly seated before each use.
> Switch off the device before putting it down.
Attachments with chain drive
EN
18