Eder Contour Planer Ekh-C - eder ESG-C 400200 Instrucciones De Operación

409001_01 | 12.2020
> Move the knife so that the cutting edge touches the Allen wrench
at the point with the desired cutting depth.
> Retighten the Allen screw of the knife.
Tightening torque: 35 Nm

EDER Contour Planer EKH-C

Sharp knives are required for optimal work with the EDER Contour
Planer EKH-C.
Blunt knives can be sharpened manually using normal
i
grinding wheels. Cutting edge angle is 40°.
For adjustment you need the supplied Allen wrench and the knife
gauge.
On the knife gauge there are notches with which you can adjust the
knives to 0.2 mm, 0.4 mm and 0.6 mm cutting depth.
Fig. 8: Cutting depths on the knife gauge
The smaller the knife protrusion, the less wood is removed
i
and the smoother the surface becomes
1
Fig. 9 Knife adjustment
> Loosen the knife screw (1 - Fig.9).
> Push the knife (2 – Fig.9) all the way back.
> Place the knife gauge (3 – Fig.9) on the cylinder (4 – Fig.9) so
that it rests on the two bearing surfaces of the cylinder at the top
and bottom.
.
2
3
4
Attachments with chain drive
EN
22