eder ESG-C 400200 Instrucciones De Operación página 55

409001_01 | 12.2020
> Fit the protective plate to the guide bar (1 – Fig. 4).
3
Fig. 4.: Mounting the protective plate
> The groove cutter has another protective plate (2 -Fig.4).
This is screwed to the housing with two hexagonal screws (3 -
Fig.4).
Chain and drive sprocket pitch
Only use chains and drive sprockets matching the chainsaw and
having the same pitch.
> Put the side plate back on the device, slightly fasten it and
tension the chain. A new chain needs to be retensioned more
often. Check the chain tension more often.
> Tighten the screws of the side plate firmly.
Chain tension
> Check the chain regularly for correct chain tension. To do
this, always switch off the engine!
> The chain is correctly tensioned if you can pull it slightly out of
the guide bar by hand with the chain brake released. The
chain must not be lifted more than 4 mm from the guide bar.
2
1
ATTENTION
ATTENTION
Attachments with chain drive
EN
16