eder ESG-C 400200 Instrucciones De Operación página 60

21 Attachments with chain drive
Fig. 6: Allen wrench with notches
To adjust the knives, you need the 6 mm Allen wrench. This key has
notches for three settings of the knives: 0.4 mm, 0.7 mm and 1 mm.
The required knife setting depends on the type of wood to be peeled.
Adjust the knives from case to case.
The smaller the knife protrusion, the less wood is removed
i
and the smoother the surface becomes.
All knives are changed and adjusted in the same way.
You can set the cutting depth to 0.4 mm, 0.7 mm or 1 mm with the
supplied Allen wrench.
The knives must not protrude more than 1 mm beyond the guide
plate.
2
Fig. 7: Knife adjustment
Proceed as follows for each knife:
> Loosen the Allen screw of the knife with a 6 mm Allen wrench.
> Replace the knife (2 – Fig.7) if necessary.
> Turn the cylinder (1 – Fig.7) so that the knife protrudes at
maximum through the guide plate (3 – Fig.7).
> Place the Allen wrench (4 – Fig.7) on the guide plate so that the
notch with the desired cutting depth is under the knife.
1
3
4
409001_01 | 12.2020