Changing And Adjusting The Knives; Eder Bark Stripper Esg-C - eder ESG-C 400200 Instrucciones De Operación

19 Attachments with chain drive
Chain brake
> On some models, frequent use of the chain brake at high
speeds can damage the drive motor.
> Only use the chain brake in emergency and dangerous
situations, with the engine running idle or when the engine is
switched off
Lubrication
> After each replacement of the guide bar, check whether oil is
being pumped through the groove of the bar. To do this,
switch the engine off again after a short running time.
> Note that the chain and the guide bar may be hot.

Changing and adjusting the knives

Damage due to blunt knives
Regularly check the cutting edges of the knives
> Working with blunt knives can damage the knives and the
bearing.
> If necessary, sharpen the knives or replace them.
Suitable tool
> Use a suitable torque wrench to tighten the knives. Never
tighten them with an extension wrench or using a hammer.

EDER Bark Stripper ESG-C

Sharp knives are required for optimal work with the EDER Bark
Stripper ESG-C.
Blunt knives can be sharpened manually using normal
i
grinding wheels. Cutting edge angle is 40°.
The required knife setting depends on the type of wood to be peeled.
Adjust the knives from case to case.
ATTENTION
ATTENTION
ATTENTION
409001_01 | 12.2020