HPA-Faip M 824 LL Uso Y Mantenimiento página 55

Inflating tubeless tyres
(TI versions only)
WARNING
Before carrying out the operations des-
cribed below, always make sure that
there is no dirt, dust or other impurities
on the jaws near the air outlet holes.
- Make sure that the wheel is secured to
the table top with inside clamping.
- Connect the Doyfe inflator chuck on the
air hose to the valve stem.
- Hold the tyre with your hands and lift it
until there is a slight gap between the
lower bead and bottom edge of the rim
in order to close the upper bead and the
top of the rim.
- Fully press the inflation pedal down for a
short period to the bead seating position
(fig. 33a). The tyre will expand and the
beads will seat.
- Continue to press the pedal in the infla-
tion position (fig. 33b) until the beads are
completely inserted.
Note: to improve the operation of the tube-
less tyre inflation system the compressed
air line pressure must be between 8/10
bar.
Operator's manual M 824 LL
TROUBLESHOOTING
Turntable does not turn
Power cord conductor shorting to
ground.
➥ Check the wiring.
Motor shorted.
➥ Replace the fuses
➥ Replace the motor.
Rotation control pedal fails to
return to the central position
Control spring broken.
➥ Replace the command spring.
Bead breaker pedal and table
top pedal do not return to home
Control spring broken.
➥ Replace the pedal return spring.
No oil in lubricator.
➥ Top up lubricator with SAE20 non-
detergent oil.
33a
Air leak inside the machine
Air leak from bead breaker cock.
➥ Replace the cock.
➥ Replace the bead breaker cylinder.
Air leak from the table top cock.
➥ Replace the turntable cylinder.
➥ Replace the swivel connector.
Bead breaker cylinder lacks
33b
force, fails to break beads and
Silencer plugged.
➥ Replace the silencer.
Cylinder seals worn.
➥ Replace the gaskets.
➥ Replace the bead breaker cylinder.
position
leaks air
EN
55