Dacor Pro DOP30 840 Serie Manual De Instrucciones página 25

Ignition
To light a burner :
1. Push in the knob and turn it counterclockwise to the Lite position. The igniter for
the burner will spark repeatedly until it lights. The spark makes a "clicking" sound.
The burner should light within four seconds. The flame should burn evenly around
the burner, except underneath each grate support finger, where the flame height is
reduced by Dacor's Smart Flame feature. A normal flame is steady and blue. Foreign
material in the gas line, especially in new construction, may cause a temporary orange
flame during initial operation. Small yellow tips on the flames are normal when using
LP gas. If a burner does not ignite, the igniter continues to spark or if the flame is not
spread evenly around the burner cap, see the Troubleshooting section on page 95.
2. Place the cooking utensil on the grate.
3. Adjust the flame to the cooking task.
NOTE
Turn off the burner if there is no spark, and verify that power is supplied to the range.
Never manually light a burner during a power failure.
DOP30T840GS_DG68-01458A-00_EN+MES+CFR.indb 25 DOP30T840GS_DG68-01458A-00_EN+MES+CFR.indb 25
NOTE
Each control knob has a corresponding
burner. The location of corresponding
burner is marked next to the knob.
English 25
2023-01-12 오후 2:41:11 2023-01-12 오후 2:41:11