Publicidad
Idiomas disponibles
Idiomas disponibles
6. Operation
To maintain a certain speed, follow the previous instruction and engage the lock
on Button. To disengage Lock-on Button, simply squeeze the Power Switch to
release.
2) General Cutting:
clear of any foreign material and that power cord and extension cord are out of the
securely clamped in a vice or with clamps to the work bench or table. Mark the line
of cut clearly. Pull in the power switch to start the cutting action. Set the shoe on
the work. DO NOT FORCE. Use only enough pressure to keep the saw cutting. Allow
the blade and saw to do the work.
3) Plunge Cutting:
Clearly mark the line of cut. From a convenient starting point within the cut out
area, place the tip of the blade over that point with saw parallel to the line of cut.
Slowing lower the saw until the button edge of the shoe rests on the workpiece.
Start the saw and allow it to attain full speed. With the saw resting on the shoe,
slowly let the saw forward to lower the blade onto the cut line. Continue this
motion until the saw blade is perpendicular to the workpiece.
WARNING
speed Adjust Dial. Failure to comply could cause loss of control and result
in serious injury.
4) Metal Cutting:
When cutting metallic material with this tool, be sure to use a sharp blade
designed for this purpose. We recommend lubricating the cutting surface with
cutting oil to avoid heat buildup. Follow general cutting procedure on previous
page. Do not force tool. Use only enough pressure to keep the saw cutting.
Make sure the blade does not touch the workpiece
until the saw reaches its max speed set on the
146
FR
ES
PT
IT
PL
UA
RO
GR
EN
Publicidad
