Publicidad
Idiomas disponibles
Idiomas disponibles
7. Maintenance
WARNING
1. Replace the saw blade according to which material to cut, as soon as its teeth
are blunt and proper sawing is therefore no longer possible.
2. Clean the appliance after completing your sawing work.
3. Remove any dirt (e.g. sawdust). If necessary, clean the saw blade mounting
with a brush or blow it out with compressed air.
8. Trouble shooting
Problem
Product does not start
Product does not reach
full power
Unsatisfactory result
Please read "WARNING" or previous section regarding check-
ing and changing of the SAW BLADE.
Possible cause
Not connected to power supply Connect to power supply
Power cord or plug is defective Check by a specialist
Other electrical defect to the
product
Extension cord not suitable for
operation with this product
Power source(e.g.generator)has
too low voltage
Air vents are blocked
Blade is worn
Solution
electrician
Check by a specialist
electrician
Use a proper extension
cord
Connect to another power
source
Clean the air vents
Replace with new blade
148
FR
ES
PT
IT
PL
UA
RO
GR
EN
Publicidad
