Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
4. Hook the upper part of the indoor unit onto the upper hook of the mounting plate.
5. Check that the unit is securely hooked into the mounting by exerting slight pressure on the left and
right sides of the unit. The unit should not shake or move.
6. Using even pressure, push down on the bottom half of the unit. Continue to push down until the unit
snaps into the hooks along the bottom of the mounting plate.
7. Again, check that the unit is firmly engaged in the mounting by exerting slight pressure on the left and
right sides of the unit.
If the refrigerant piping is already recessed in the wall, do the following:
1. Hook the top of the indoor unit into the top hook on the mounting plate.
2. Use a bracket or a wedge to prop up the unit, which will give you enough room to
2. Use a bracket or a wedge to prop up the unit, which will give you enough space to connect the refrige-
rant pipe, signal wire and drain hose.
Cuña
3. Connect the drain hose and coolant pipe (refer to the Coolant Pipe Connection section of this manual
for instructions).
4. Keep the pipe connection point exposed for leak testing (refer to the Electrical Checks and Leak Chec-
ks section of this manual).
5. After the leak test, wrap the connection point with duct tape.
6. Remove the bracket or wedge holding the unit.
7. Using even pressure, push down on the bottom half of the unit. Continue to push down until the unit
snaps into the hooks along the bottom of the mounting plate.
The unit is adjustable
Note that the hooks on the mounting plate are smaller than the holes on the back of the unit. If you do
not have enough space to connect recessed piping to the indoor unit, the unit can be adjusted to the left
or right by 30-50 mm, depending on the model.
30-50mm
Mover a la izquierda o a la derecha
68
30-50mm
English
infiniton.es
Publicidad
