Publicidad
Idiomas disponibles
Idiomas disponibles
How to use
English
8. UP / DOWN
* Each time UP is pressed, the temperature setting will increase by 1°C, and each time DOWN is pressed,
the temperature setting will decrease by 1°C.
* If the remote controller type is YKR-H / 101 E or YKR-H / 102E, the temperature setting range is 16 ~ 32 °C.
* If the remote controller type is YKR-H / 132E, the temperature setting range is 20 °C ~ 28 °C.
Note: The temperature cannot be adjusted in AUTO or FAN mode, therefore, these two buttons do not
work.
9. TURBO
* Press this button only in COOL or HEAT mode to activate or deactivate TURBO to speed up cooling or
heating.
* When TURBO is on, the air speed is HIGH.
* When TURBO is deactivated, the air speed returns to the previous state.
10. MODE
* Press this button to select the operation mode:
AUTO->COOL->DRY->HEAT ->FAN
(Auto->Cool->Dry->Dehumidifier->Heat->Fan)
Note: HEAT mode is not available for cooling only units.
11. SLEEP
* Press this button to enter SLEEP mode, which will switch off the unit after 10 hours of continuous opera-
tion and restore the previous status.
Note: The SLEEP function cannot be activated in FAN mode.
12. VERTICAL OSCILLATION
* Press this button to activate the up/down movement and press it again to set the movement position.
13. HORIZONTAL OSCILLATION
* Press this button to activate the left/right swing and press it again to set the swinging position.
14 .Anti-F
* Anti-F operates when the unit is turned off with the remote controller in COOL mode,
DEHUMIDIFIER or AUTO mode. It will operate in HEAT mode (FAN mode only for cool units), with the internal
fan running at a low flow rate for 3 minutes before stopping, to remove moisture from inside the evapo-
rator and prevent it from giving off bad odour caused by mould.
* This function is not factory set. You can set or cancel it at any time as follows: with the unit and remo-
te controller off, point the remote controller at the unit and press the "Anti-F" button once, after 5 times,
an acoustic signal will sound, indicating that this function is set. Once set, this function will remain valid
except when the unit is turned off or until it is cancelled.
* To cancel Anti-F:
1. Turn off the unit.
2. With the unit and remote control OFF, point the remote control towards the unit and press this button
once, after 5 times an acoustic signal will sound 3 times, indicating that this function is cancelled.
Note:
With the Anti-F function activated, it is recommended not to turn on the unit again before it is completely
turned off.
* The Anti-F function will not be valid when the sleep timer is set.
88
infiniton.es
Publicidad
