Publicidad
Idiomas disponibles
Idiomas disponibles
How to use
English
1. ON/OFF
* Press this button to turn the unit on or off.
* This will clear the existing timer and SLEEP setting.
2. ºC / ºF
* Press this button to adjust the temperature display in degrees Fahrenheit, the default is degrees Cel-
sius. The "ºC" will not be shown on the LCD display.
* Press this button again to reset the temperature display in degrees Celsius.
Note: Fahrenheit temperature display is not available for some models. When the temperature is displa-
yed in Fahrenheit on the remote control, it may be in Celsius on the unit, whose performance and opera-
tion will not be affected.
3. SPEED
* Press this button to select the fan speed as follows:
Low -> Mid -> High -> Auto
The airflow speed in Auto mode is not available in Fan mode.
4. DISPLAY
* Press this button to turn the display on or off. This is for users who do not wish to sleep with the display
on.
5. iFEEL
* Press this button to set the temperature display on the remote control to room temperature and press
this button again to set the preset temperature.
6. TIMER
* With the unit on, press this button to set the sleep timer, or with the unit off to set the on timer.
* Press this button once and "ON (OFF)" will be flashing. Press the " UP " or " DOWN " button to set the
number of hours the unit will turn on/off, with an interval of 0.5 hours if it is less than 10 hours, or 1 hour if it
is more than 10 hours, and a range of 0.5- 24 hours.
* Press again to confirm the setting and "ON (OFF)" will stop flashing.
* If the timer button is not pressed for more than 10 seconds after "ON (OFF)" starts flashing, the timer
setting will be cancelled.
* If the timer setting is confirmed, pressing this button again will cancel the timer setting.
Note: When a power on timer is set, all function buttons (except SLEEP, DISPLAY and iFEEL cannot be set)
are valid and when the power on time is set, the unit will operate as a preset.
7. Health / iClean button. This button has two functions:
A. Health
Press this button while the unit is on to activate health related functions, such as negative ions, electros-
tatic precipitation, PM2.5 removal, etc., depending on the actual configuration of each model.
* Press this button again to deactivate the HEALTH function.
B. iCLEAN
* Press this button when the unit is off, the remote controller will display "CL" and the unit will automati-
cally clean the dust from the evaporator and dry it, to increase the cooling and heating efficiency.
The iCLEAN function operates for approximately 30 minutes, during which time, if the unit is turned on
with the remote controller or this button is pressed again, iCLEAN will be deactivated.
87
infiniton.es
Publicidad
