Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Step 2: Install the drainage gasket (heat pump unit only)
Before screwing the outdoor unit in place, you must install the drainage gasket on the bottom of the unit.
Note that there are two different types of drainage gaskets depending on the type of outdoor unit.
If the drainage gasket comes with a rubber seal (see Fig. A), do the following:
1. Place the rubber seal on the end of the drain gasket that will be connected to the outdoor unit.
2. Insert the drain gasket into the hole in the pan at the base of the unit. 3.
4. Turn the drain gasket 90° until it snaps into place facing the front of the unit.
5. Attach a drain hose extension (not included) to the drain joint to redirect water from the unit during
heating mode.
If the drain joint does not come with a rubber gasket (see Fig. B), do the following:
1. Insert the drain gasket into the hole in the pan at the base of the unit. The drain gasket will snap into
place.
2. Connect a drain hose extension (not included) to the drain joint to redirect the water from the unit
during heating mode.
Note: In cold climates, make sure the drain hose is as vertical as possible to ensure rapid drainage of
water. If the water drains too slowly, it may freeze in the hose and flood the unit.
Orificio del plato base
de la unidad exterior
Sello
Sello
Junta de drenaje
Fig. A
70
Fig. B
English
infiniton.es
Publicidad
