EFFEKTIV TRIUMPHATOR 2000X Manual De Usuario página 7

Changing the Needles
12
Adjustment of Differential Dial
The differential dial can be altered
by turning the dial.
The number on the dial indicates the
ratio between the main and the sub
feed motion.
• Set the dial at 1.0 for regular
sewing.
• Set the dial at a lower number
when sewing fine fabrics that
tend to pucker.
• Set the dial at a higher number
when sewing stretch fabrics
such as knits, jersey and tricot.
Differential dial

Setting mark

To shrink

To stretch

Turn the Balance wheel toward you to
raise the needle to its highest position.
 Balance wheel
Then loosen the needle clamp screw for
the needle you are going to remove.
Needle clamp screw Hexagonal
 
wrench
Insert a new needle into the needle clamp
with the flat side to the back and push it
up against the stopper, then tighten the
needle clamp screw.
Flat side

EN USER MANUAL
NOTES: Use needles EL X 705 CF. Do not use any needle which is bent or
blunt.
TRIUMPHATOR 2000X
WARNING:
Turn the power switch off and unplug
the machine before changing needles.
Needle Threader
To attach the needle easily, use the
end of the needle threader to hold the
needle.
Insert a needle into the needle threader/
holder with the flat side facing back as
shown.
Hold the stem and insert the needle into
the needle clamp and push it up as far
as it will go.
Tighten the needle clamp screw firmly
while supporting the holder in place.
Pull the holder own to remove it.
Needle threader / holder

Setting the Telescopic Thread
Guide
Pull the telescopic thread guide up
as far as it will go. Turn the it so that
the thread guides are right above the
spool pins.
Telescopic thread guide

Three-extension rod

Spool stand base

Stoppers

NOTE: Make sure the two stoppers on
the thread guide post, as shown, are
set in at the correct position.
13