SERIAL NUMBER PLATE
INFORMATION
Each machine carries a plate Fig. 1a featuring
data for its identification and some technical data.
As well as the manufacturer's details, it indicates:
Mod. - Machine model;
V - Power supply voltage in Volts;
A - Input voltage in Amperes;
kW - Absorbed power in kW;
Hz - Frequency in Hz;
Ph - Number of phases;
bar - Operating pressure in bar;
Serial No. - machine serial number;
ISO 9001 - company Quality System Certification;
CE - CE marking.
ProLine 60 - Operator's Manual
2. INSTALLATION AND
Before installation and use of the wheel balan-
cer, you should carefully read this installation
and operation manual. And keep this manual in
hand for reference at any time. You should be
sure that all the operators have read this manual
to guarantee the most perfect functions of the
machine and meanwhile the safety.
2.1 PROTECTIVE HOOD
Shown in page 29.
2.2 MAIN SHAFT INSTALLATION
Before installation, use the ethyl alcohol and
compressed air to clean up the center hole of the
shaft and connect part. Use spanner and screw
to fix the thread shaft on the balance shaft (Fig2)
1
2.3 ELECTRICAL CONNECTION
According to the label on the connect between
power cable and body, the power cable con-
nect socket must be grounded with the reliable
earth wire.
All the electrical devices installation must be
done by the qualified staff. Before installation,
please check
If the power system is comply with the technical
OPERATION
INSTALLATION
& EARTHING
UK
2
37