Corghi ProLine 60 Manual De Uso página 43

6.2 DISPLAY PANEL
& CONTROL PANEL
1. In the state of parameter input, it is the
stance from wheel to balancer input key .You can
change the Br set value of the window by press
the up/down key.
2. Br value input key You can change the Br set
value of the window by press the up/down key.
3. In the state of parameter input, it is the diameter
of the rim input key. You can change the D set
value of the window by press the up/down key.
4. High accuracy balance key: When
thedisplay displays[ 00], press this key the di-
splay will display the unbalance value less than
5g.
5. Unit conversion key can convert the
unit of the unbalance value and size.
6. Balancing mode selection key.
ProLine 60 - Operator's Manual
7. Function key & confirm key.
8. Emergency stop key.
9. Start key
parameter of the tire display.
di-
11. Outside unbalance value and
tire parameter display.
13. Balancing modes display lamp
6.3 BASIC OPERATION
6.3.1 Before operation, please confirm that
you have read the entire warning label and
the instruction manual. Not according with the
safety instruction can cause the injuries to the
operators & bystanders.
6.3.2 Preparation before test：Check and clean
the dust and mud and if there are foreign bodies,
such as metal and stone, clipped on the surface
of the tire. And also check the air pressure of the
tire is according with the specified value. Check
if there are deformation on the rim positioning
surface and installation hole.
Check if there are any foreign bodies in the tire.
Take off the original weight.
10. Inner unbalance value and
12. Unbalance position lamp.
UK
43