Corghi ProLine 60 Manual De Uso página 45

Br of the rim, press the key
to input the Br value into the display. At this
moment, the display will display [Br.]:[XXX].
And the default system is inch.
6.4.3 Input the DiA (Diameter) Tire Diameter
Value
After confirming the rim diameter, press the key
to input the rim diameter
into the display. At this moment, the display
will display [Dia]:[XXX]. And the default system
is mm.
6.4.4 UNIT CONVERSION
1. The unit conversion of the Br of the rim from
inch to mm:
Normally, the display of Br should be in inch.
When you need the unit of the display to be
mm, you can use the key
unit conversion from inch to mm.
2. The unit conversion of the DIA of the rim
from inch to mm:
Normally, the display of D should be in inch.
When you need the unit of the display to be
mm, you can use the key
unit conversion from inch to mm.
After unit conversion, the unit of the display
values of rim Br and D are , but when you switch
off and then on the wheel balancer, the unit will
be still inch.
3. The unit conversion from gram to ounce
Normally, the unit of the unbalance value is gram
(g). If you want to make the ounce(Oz) to be the
unit, you can execute the g/Oz conversion. The
unit of the displayed unbalance value is gram(g).
The way to realize the unit conversion from gram
to ounce is to press
6.4.5 When press the start keys
balancer starts to run. A few seconds later, the
machine automatically stops. The machine can
also start by lowering down the protective hood
which can be set by the program.
ProLine 60 - Operator's Manual
to realize the
to realize the
.
, the wheel
6.4.6 DISPLAY UNBALANCE VALUE
When the spin ends, the display will display
the inner
unbalance value of the rim. Use your hand to
pull the wheel. When all the positioning lamps
light inside and outside light, the weight adding
position will be indicated.
6.4.7 Rotate the wheel, when the left side posi-
tioning lamp all light, at this moment, the highest
position is the inner unbalance position and
when the right side positioning lamp all light, at
this moment, the highest position is the outer
unbalance position.
6.4.8 Add the corresponding weight at the
unbalance point and start test again until the
balance of the tire.
CAUTION
1. When start the machine, use hand to pull the
wheel to help it start rotation, especially to the
relative bigger tire, to prolong the working life
of the motor.
2. Check if there are any mistakes on the dimen-
sion.Check if the balance methods meet the
configuration of the rim and select the balancer
most easily to balance.
3. Check if the quick lock nut tight or not.
4. When the balance ends, remove the tire. Pay
attention to handle it with gentle and avoid
knocking the main shaft.
5. When clipping the weight. Use the hammer
to clip
the weight on the rim without too much force.
Do not knock the main shaft hardly to avoid
damaging the sensor. The position to add the
Weight should be free from the grease and
should be dry.
and outer
45
UK