Corghi ProLine 60 Manual De Uso página 38

parameter marked on the nameplate of the
machine.
The wiring of the machine must have the fuse
and the perfect ground protection. And install
the electrical
Leakage automatic controls switch in the power
source. And recommend the application of the
stabilizer
if the voltage of installation site is unstable.
WARNING
Any electrical connect in the workshop is only done
by the qualified technical staffs and it should meet
the enforced regulation. .
Any electrical connect must be according to the
following:
• Power on the data plate on the machine;
• Voltage decrease can not exceed 4% of the
rated voltage on the data plate when full load
(10% when start)
-Operators must:
• Install the plug;
• install 30ma circuit breaker;
• install power cable fuse;
• provide with effective workshop electrical con-
nect to ground;
- prevent the authorized operation and pull out
the plug to prolong the working life when not use
the machine.
- if the machine directly connected to the power
source through the power board not the plug, we
should use the qualified staffs to operate.
WARNING
Perfect ground is necessary for the correct
operation. Do not connect the machine with air
pipe, water pipe, telephone line and the other
unsuitable objects.
38
3. TECHNICAL FEATURES
3.1 FEATURES
- adopts quality computer with the feature of high
intelligence and high stable
- mechanical main shaft adopts high precision
bearing driven, wear-resistant, low noise
- press stop key to realize the emergency stop
- full automatic dynamic/static balance check
- balance 3 ALU rim and 1 motorcycle tire
- self-calibration and full automatic trouble
diagnosis
3.2 MAIN TECHNICAL
SPECIFICATION
- rated voltage: 220V/110V (selectable) 50/60HZ,
380V/50HZ/1P
- power ............................................................250W
- speed ... 7S (if the weight of the wheel is about
20Kg)
- accuracy .......................................................... ±1g
- noise ............................................................ ≤69dB
- rim diameter ........................................... 10°~24°
- maximum wheel weight ...............................65kg
- rim width .................................................. 1.5~20*
- max wheel diameter ..................................44inch
- machine weight with protection (without acces-
sories) ..........................................................107kg
Machine dimensions:
- depth with guard closed ..................... 1105 mm
- depth with guard open ........................ 1044 mm
- width with guard ................................... 1135 mm
- height with guard closed ..................... 1278 mm
- height with guard open ........................ 1708 mm
- depth without guard .............................. 595 mm
- width without guard ............................. 1080 mm
- height without guard ............................ 1012 mm
ProLine 60 - Operator's Manual