Corghi ProLine 60 Manual De Uso página 46

6.5 RESIDUAL UNBALANCE
VALUE DISPLAY
The minimum value of the standard weight is
5g so if the weight you use is less than 5 g, the
wheel balancer will not display the value and
only displays the state of "00". When you need to
display the residual unbalance value, you should
press and the display will immediately
display the inside or outside unbalance value of
less than 5g. The maximum residual unbalance
value is 4 g.
6.6 BALANCE MODE SELECT
Press the corresponding
key to choose the balance mode. If all the lights
not light up, it is the dynamic mode.
DYNAMIC: clip the weight on both sides
of rim (dynamic balance test once start)
STATIC: Stick the weight in centre
MOT: Optional for balancing the motorcycle
When balancing motorcycle wheels, you require
the (optional) motorcycle adaptor accessory MJ-
II. With the assistance of the extension scale to
measure Di, Br and Di. Input the measure value
into the Di, Br and Di display window. The input
method is similar to the parameter input of the car.
ALU1: to balance the light aluminum alloy
rim. Adopt clip the weight on the shoulders of
the rim.
46
ALU1
Dis 1 = Dis + 3/4"
Dis 2 = Dis + Br - 3/4"
Dia 1 = Dia - 1"
Dia 2= Dia - 1"
ALU2: for ALU rim, hidden weight inside.
ALU2
Dis 1 = Dis + 3/4"
Dis 2 = from 0 point to the outer of the flange disk-1/2"
Dia 1 = Dia - 1"
Dia 2 = Dia - 2 1/2"
ALU3: clip the weight inside and the
position to add weight outside is same to ALU2.
ProLine 60 - Operator's Manual